NIS2: where to start when you run an industrial site
Member states had to transpose the European NIS2 directive by October 2024; in France, transposition is under way. For many industrial SMEs and mid-caps, it will be the first cybersecurity regulation that applies to them directly. The first expected measures, knowing one's network and analyzing one's risk, can be prepared now.
Who is concerned, and when
NIS2 clearly widens the scope of the previous directive: the bill's impact study estimates that around 15,000 entities, between 10,000 and 18,000, are concerned in France. Several industrial sectors are concerned: food, chemicals, manufacture of medical devices, electronics and machinery, water and waste management, energy. Depending on its sector, then its size, an entity is “essential” or “important”; both categories fall under the same risk-management measures, but not under the same supervision regime.
In France, the resilience bill, which transposes NIS2, passed the Senate in early 2025; its reading at the National Assembly was still awaited at the time of writing. Update of 18 November 2026: the National Assembly adopted the bill in first reading on 17 November 2026. As the two chambers did not vote the same text, a joint committee must still meet; the law's promulgation and its decrees will follow, with no date yet. This delay leaves time to prepare the first measures without urgency.
What ANSSI's framework describes
ANSSI's framework for implementing NIS2 in France, the ReCyF (working document, version 2.5), describes twenty security objectives. Two of them directly concern the shop floor:
- Mapping of assets and information systems: knowing what is connected, including in production (PLCs, HMIs, SCADA, gateways, remote maintenance).
- Risk analysis: identifying feared scenarios, scoring the risk, deciding measures and documenting the whole. The framework sets no review period for important entities; a regular review remains a good practice, which we recommend without making it an obligation.
Essential entities have further objectives, including regular audits, hardening and supervision. For most industrial sites, the work starts with these two points: knowing one's network, then scoring one's risk.
Not limiting the effort to corporate IT
A NIS2 effort often starts with corporate IT: e-mail, workstations, servers. That work is needed, but the industrial network is often less well documented, and an incident there has physical consequences. A PLC reachable from the office network, a supplier's remote maintenance left open or an industrial protocol crossing levels cannot be seen from corporate IT. They show in the shop-floor network traffic.
A four-step method
- 1. Map passively. A probe plugged into a mirror port of the industrial network inventories devices and flows without sending a frame: it talks to no production device. The map fills in over the days of listening, as production cycles run.
- 2. Structure into zones and conduits. IEC 62443, the technical reference for industrial systems security, divides the site into homogeneous zones linked by controlled conduits. The division starts from the observed map rather than from a theoretical diagram.
- 3. Analyze and score the risk. Threats, vulnerabilities and scenarios per zone, risk scoring before and after countermeasures. This step addresses the risk-analysis objective NIS2 aims at, with the IEC 62443 grid.
- 4. Document and review. A dated report describes the analysis, its assumptions and its action plan. It is revised when the site changes and can be handed to an auditor, an insurer or a principal.
What Ultrametrix offers
The UMX suite supports these four steps. UMX Explorer performs the passive mapping of the industrial network (inventory, Purdue levels, flows between levels). UMX Risk Manager builds the IEC 62443 risk analysis from it: zones and conduits, scenarios, scoring and reports. Ultrametrix can also carry out or co-produce the analysis with your teams, from mapping to the final report, then make you autonomous.
Both products run offline, without telemetry. UMX Explorer is free.